Hi Guys,
A few of you have mentioned about doing this.  I though I'd put together a summary article on how it's done.

Firsly you need to get a set from somewhere.  These are the set that I bought from ebay for $45 inc postage:
http://cgi.ebay.com.au/ws/eBayISAPI.dll … 0074883743

Mickey got his from a bugeye wreck for $30.

One of the other blokes on here (can't remember handle) got his from autobarn for $30.

Tools:
- None

This is what the package arrived like.  There were no instructions but I figured it out and am writing this instead:


The before shot.  Note Sherlock the faithful helper and purveyor of all things good acting a Site Foreman (as he aslways does when I'm fiddling with stuff around the house).  He just has to give the "Sherlock patented seal (read as sniff) of approval".


Step 1 - Push the repeater forwards.  This should free up the rear end and you should be able to pop it out.  There is no need for a screwdriver here as you'd more than likely scratch the paintwork (like I might have done).


Step 2 - Remove the wire plug from the indicator.  There is a little clip at the base of the plug that needs to be pushed in first.

Step 3 - Remove the centre-piece from the old indicator (you'll need this) and then put the new (clear) amber globes in that and then insert the lot into the new lense cover and re-attach the plug.  It should look like this:


Step 4 - Insert the new clear indicator assembly at the front of the hole and then slide backwards.  This might be a tight fit but it does go in.  It should look like this:


After shot:


Hope that helps all contemplating this upgrade.

2 days after I bought my repeaters, I saw another set on ebay for like $28.  I was so dark but ohh well no point crying over spilt milk.

Cheers
Darryl