I can assure you there's two holes behind the RX badge. I don't believe there's any behind the bilstein badge though. Not sure about the AWD one.

Gen2s look a bit funny without any badging at all in my opinion...

I removed all mine and had the holes welded up. (tailgate needed respray) I like the look of no badges and a clean panel but i was going to put a GT badge on anyway to distinguish the car.

No badges



GT badge

I like the look of no badges. Like Mark i removed them and had the holes welded

Sorry boys, the rear looks too much like a Commo without any badges for me....

Maybe you should attach yours with some colour-coded velcro walts?
I don't know why it reminds me of a commodore, it just does. That's only the gen2 mind you, the gen3 not so much...

i removed the liberty GX badge and cut the gx part off then used some clear, industrial strength double sided tape to re-apply the liberty badge (it's not a legacy, why lie about it) with the AWD badge underneath... (liberty and awd badges on one side, nothing on the other... though if i could find a decent looking, decent sized 3.0r badge, i might put it on, the only h6 related badging on my car other than on the motor is a little one under the gear shifter (about 50mm x 10mm))

i'll get pics if anyone wants...

edit: i uploaded a pic (yes my car's rear wheel is in the air, coilovers + swaybar ftw!):


i think it looks bloody brilliant!

edit again: yes i realise my rear right quarter panel and right side of the rear bar are a different colour to the rest of the car, and that the paint on the rear bar is rooted...

i'm getting it fixed when i get the car repaired from my recent accident...